
Terminal/Telnet Commands
155
TPI-PRO/DVI (Total Presentation Interface)
Terminal/Telnet Commands
Overview
The following telnet/terminal commands are supported by the TPI-PRO/DVI, via the SERIAL (DB-9) port on
the front panel (see the SERIAL Port section on page 17).
Terminal/Telnet Commands
disk free Show the amount of free space on the disk.
get dns Show the DNS configuration of a device.
get ip Show the IP configuration.
get config Show the current configuration.
mem Shows size of the largest block of available memory.
msg on|off Enables/Disables extended diagnostic messages.
ping [address] Pings an address. Address may be an IP or URL.
reboot Reboots the device.
set dns Setup the DNS configuration of a device.
set ip Setup the IP configuration of a device.
show log <start> Display the message log.
• <start> specifies message to begin the display.
• 'all' will display all messages
show mem Display the memory usage for all memory types (requires msg on).
setup Display setup page on panel.
get cache enable Get the state of the image cache flash backup
get cache expire Get current expiration time for image cache entries
get cache size Get flash cache maximum size
get cache Display all image cache parameters.
toggle cache enable Toggle the state of the image cache flash backup
cache purge [mask] Purge image cache (bit 0=NV, bit 1=RAM)
set cache expire Set expiration duration for image cache entries
set cache size Set flash cache maximum size
show connection log Show the connection logs for the panel.
show connection stats Show the connection stats for the panel.
get connection Show the master settings.
get device Show the device number.
set device Setup the device number.
set connection Setup the master settings.
version Display the version(s) of the units components.
temp info Display the temperature sensor data.
input stats [1-4] Display the video input statistics.
Terminal Only
echo on|off Enables/Disables echo of typed characters.
Comentários a estes Manuais