AMX RPMLoader Manual do Utilizador descarregar pdf (Página 12)

Configuring the NXB-CCG

RPM Device Configuration Guide - NXB-CCG NetLinx Clear Connect Gateway

1. In the NXB-CCG’s WebConsole Add Devices page, click Add/Remove Devices to enter "add/remove devices

mode" (FIG. 19):

The program will indicate that it is entering "add/remove devices mode" (FIG. 20):

In this mode, the NXB-CCG will wait for a device to be identified.

When "add/remove devices mode" is active, the WebConsole will prompt you to press and hold a button on

the sensor (FIG. 21):

2. To add the sensor, press and hold the Lights Off button (see FIG. 18) for approximately 4 seconds, until the Device

Heard popup appears in the WebConsole (FIG. 13) indicating the type of device that reported itself (in this case, an

Occupancy Sensor):

3. Enter a unique name for the sensor and click the Add button. This closes the Device Heard popup and returns to the

Add Devices page, still in "add/remove devices mode".

4. Click Done to exit "add/remove devices mode" (FIG. 14):

5. Note that the Occupancy Sensor is now indicated in the Devices list. In the example shown in FIG. 24, the sensor

added was named "Sensor":

FIG. 19 NXB-CCG WebConsole - Add Devices page (Add/Remove Devices button)

FIG. 20 NXB-CCG WebConsole - Entering add/remove devices mode

FIG. 21 NXB-CCG WebConsole - Add/remove devices mode active

FIG. 22 NXB-CCG WebConsole - Device Heard popup (Occupancy Sensor)

FIG. 23 NXB-CCG WebConsole - Exiting "add/remove devices mode"

FIG. 24 NXB-CCG WebConsole - "Sensor" added

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Sem comentários

AMX RPMLoader Manual do Utilizador Página 12