AMX i!-ConnectLinx Informações Técnicas descarregar pdf (Página 36)

Custom Device Monitoring Programming

RMS NetLinx Programmer’s Guide

RMSTransportMod

This module monitors transport devices. For each transport device, this module

will register and monitor online/offline status, communication status, power, and

run time. Communication status is registered only if the device is a two-way

device. This includes serial devices and IP sockets. Control failure is register only

if enabled via a SEND_COMMAND, and is based on the ability to control

power. If the device is an IP-based device, the IP address NetLinx is

communicating with is also registered with RMS. Run time is determined by

counting the time that the device is in a transport state other than stop while the

power is on.

The following diagram is a visual description of the architecture of the

RMSTransportMod module:

FIG. 5 Architecture of The RMSSldProjMod Module

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 121 122

Sem comentários

AMX i!-ConnectLinx Informações Técnicas Página 36