Installation of GRAFIK5000 / GRAFIK6000 / GRAFIK7000 System 21
Location of LED
Power Board
CSD Link
PP Link
IP Link
UI Link
Ethernet
Front of CSD
Circuit
Selector
Dimmer /
Module
Problem Indicator / Possible Cause
Name
Normal Operation
PWR
PWR
STAT
ACT
TX
RX
TX
RX
PWR
TX
RX
ACT
LNK
none
DATA
PWR
Value
none
On
On
Off
Flashes Rapidly
Flashes Rapidly
Flashes Dimly
On Dim
On Dim
On
Irregular Flash
Irregular Flash
Irregular Flash
On
On (if button
pressed)
Flashes 1 per sec
On
OK
Flashes 1 per sec
Off
Off
On
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
Flash
Rapid
Off
Off
Slow
Rapid
• No power from transformer - check if power feed
and switch are On
• Short on CSD Link - wire 2 to 1 or ground
• Processor in self-test - contact Lutron
• No database loaded
• No database loaded
• No data received - Power Panel not addressed or
check wires 1, 3, and 4
• No database loaded
• No data received - Link not used or check wires 1,
3, and 4
• Short on UI Link - wire 2 to 1 or ground
• No communication to computer
• No communication from computer
• No activity on network, if connected
• No network detected - check wiring
• No power - wires 1 and 2 miswired, or
• If On then Off, CSD not programmed
• Those that flash have the same address, or
• Miswire - check wires 1, 3, and 4
• Miswire of wires 3 and 4
• Control Breaker off
• Circuit Selector timed out - press any button
• No communication from Circuit Selector
• Shorted Triac - contact Lutron
LED Diagnostics
Processor Panel
CSD
Power Panel
LED problem indicators:
• ‘Flash’ on CSD is all LEDs turning On for
approx. 1 second, then off 3 seconds
• ‘Rapid’ on a Circuit Selector is any rate
faster than the “Heartbeat” of once per
second
• ‘Rapid’ = “Flutter” on a Dimmer/Module is one
LED turning On approx. 5 times per second
• ‘Slow’ on a Dimmer/Module is one LED
turning On approx. once per 7 seconds
Comentários a estes Manuais