AMX Current Sensors PCS Manual de Instruções descarregar pdf (Página 12)

Installation

Axcent

and Axcent

Pro Integrated Axcess Controllers

Program connector (front and rear panels)

Connect a programming cable to the PROGRAM connector on the controller. The table below

shows the DB-9 connector pins and signals for the PROGRAM connector. Use the PROGRAM

connector to download Axcess programs, and to set up control communication options using the

OpenAxcess software program.

Axcess card slot connector (Axcent

PRO only)

FIG. 10 shows the 16-pin (male) connector that provides connection to the Axcess Control Cards.

After installing control cards, refer to the literature provided with the control card for wiring and

Axcess programming information.

Program Connector and Pinouts

Pin Signal

2RXD

3TXD

4 +12 VDC

5GND

7 +12 VDC

Pin 1

Pin 9

PROGRAM pins 1, 6, 8, and 9 are not used. Pins 4, 5, and 7 are for an ALF

Programming Unit.

FIG. 10 Axcess Control Card 16-pin connector

SLOT 4

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Sem comentários

AMX Current Sensors PCS Manual de Instruções Página 12