Amx NetLinx Integrated Controllers NI-3000 Manual do Utilizador Página 133

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 132
Troubleshooting
127
NetLinx Integrated Controllers
Troubleshooting Information (Cont.)
Symptom Solution
During the firmware upgrade
process, NetLinx Studio failed to
install the last component.
This occurs when initially upgrading the on-board Master from a
previous firmware (build 117 or lower), to the new Web Security
firmware (build 130 or higher).
Only upon the initial installation of the new build there will be a failure
of the last component to successfully download. This is part of the
initial update procedure and will not occur during uploads of later
firmware.
After the last components fails to install, click Close and reboot the
on-board Master by selecting Tools > Reboot the Master
Controller > Continue to continue the process.
After the last components fails to install, click Close and reboot the
Master by selecting Tools > Reboot the Master Controller > Continue
to begin the process.
Refer to the Upgrading the On-board Master Firmware via an
IP section on page 46 for detailed procedures.
Vista de página 132
1 2 ... 128 129 130 131 132 133 134

Comentários a estes Manuais

Sem comentários