Amx Sensors and Receivers IR Manual do Utilizador

instruction manualControl Panel AccessoriesIR Sensors and Receivers

Product Information6IR Sensors and Receivers

Wiring and Installation7IR Sensors and ReceiversWiring and InstallationBefore installing the sensors and receivers, set the receive frequency on the u

Wiring and Installation8IR Sensors and Receivers! To receive 455 kHz, position the jumper (both jumpers on the receivers) on the left two pins, pins 1

Wiring and Installation9IR Sensors and ReceiversAs an example, the DIP switch in FIG. 12 defines device number 129 (1+128=129).If you later change the

Wiring and Installation10IR Sensors and ReceiversWiring the IR Sensors and ReceiversThe IR Sensors and Receivers use a four-pin AXlink connector for p

Wiring and Installation11IR Sensors and Receiversthe receiver or sensor and the Central Controller. The maximum wiring lengths are based on a minimum

Wiring and Installation12IR Sensors and ReceiversUse a 12 VDC power supply when the distance between the Central Controller and the sensors or receive

Wiring and Installation13IR Sensors and ReceiversIf the LED is on and not flashing, disconnect the AXlink connector and recheck all AXlink connections

Wiring and Installation14IR Sensors and ReceiversMounting the Swivel-Mount Sensor or ReceiverFIG. 19 gives dimensions for the AXD-IRSM+ and IRX-SM+.To

Wiring and Installation15IR Sensors and ReceiversInstallation method BUse when installing a swivel-mount unit using the provided mounting bracket.! On

AMX Limited Warranty and DisclaimerAMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three

Wiring and Installation16IR Sensors and Receiversa. Connect the unit to AXlink data/power bus.b. Check the AXlink LED. (LED should blink once per se

Wiring and Installation17IR Sensors and Receivers

AMX reserves the right to alter specifications without notice at any time.brussels • dallas • los angeles • mexico city • philadelphia • s

Table of ContentsiIR Sensors and ReceiversTable of ContentsProduct Information ...

iiIR Sensors and ReceiversTable of Contents

Product Information1IR Sensors and ReceiversProduct InformationThe AMX infrared (IR) sensors and receivers (AXD-IR+, AXR-IRSM+, IRX-DM+, and IRX-SM+)

Product Information2IR Sensors and ReceiversThe swivel-mount units:! Install on the ceiling or wall, and can be positioned horizontally or vertically!

Product Information3IR Sensors and ReceiversThe following table lists the AXR-IRSM+ specifications.IRX-DM+FIG. 4 shows the IRX-DM+ Decor IR sensor.The

Product Information4IR Sensors and ReceiversThe following table lists the IRX-SM+ specifications:.ApplicationsUse the sensors and receivers with AMX t

Product Information5IR Sensors and ReceiversFIG. 7 illustrates an application using a receiver, the AXD-IR+ (the application could also use the AXR-IR