AMX RADIA LIGHTING CONTROL SYSTEM (CONTROLLERMODULESCARDS) Manual do Utilizador descarregar pdf (Página 9)

Radio power section

The radio power section

is the partner of the radio

observer. Upon receiving

a signal, it switches con-

nected lights on and then

off again after the set

delay time has expired.

For optimum all-round

protection, a radio power

section can be combined

with up to 30 additional

radio observers.

This is especially practical,

e.g. during a garden party:

With the radio wall trans-

mitter or radio remote

control, the observer

function can be disabled.

During this time, the ligh-

ting stays switched on

or off, your choice.

Radio presence detector

The radio presence de-

tector is mounted on the

ceiling and monitors an

area with an 8 m diameter

below it. If a certain

brightness value is under-

shot and the radio pres-

ence detector then senses

a movement, it activates

the radio actuator to

switch on the light.

In conjunction with a

dimmer, it can adjust

the lighting to a constant

value. If no movement

can be recognized or if it

is bright enough, the radio

actuator is switched off,

and thus also the light.

This functionality is con-

venient and saves energy,

e.g. at the workplace or

in the conference room.

Radio observer 180/16

The radio observer can

do everything the conven-

tional Gira observers

can, but it doesn’t need a

mains connection thanks

to its being supplied by

battery. For this reason,

radio observers can be

attached anywhere they

would have the best

“overview”, e.g. even

in the garden or at the

garden gate.

Radio automatic

control switch

The radio automatic

control switch enables

simple upgrading with

convenient lighting con-

trol, as it can be adhered

or screwed directly to a

way anywhere without

a cable or flush-mounted

box thanks to its compact,

battery-powered nature.

When below the set

brightness value, it acti-

vates radio actuators or

power sections which

switch on the connected

lights. The light is switched

off after movement has

stopped for a while.

The brightness switching

threshold, the daily ope-

ration and the sensitivity

can be set for an optimum

adjustment to the local

conditions. The delay peri-

od can also be set when

using the radio power

section.

Movement-dependent light control via radio:

Ideal for subsequent installation in passageways

such as stairwells and foyers, for example.

Application example with:

01 Radio automatic control switch

02 Radio top unit for switching and dimming

03 Radio switching actuator

02 0301

Radio sensors Radio power section

9

43872_Fachinfo_Funkbus_GB 24.08.2005 9:04 Uhr Seite 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comentários a estes Manuais

Sem comentários