AMX MAX-HT12T Manual de Instruções descarregar pdf (Página 28)

MXT/D-1000 - 10.1" X Series Panels

MXD/T-1000, MXD/T-700 and MXD-430 Modero X Series® Touch Panels

Removing the MXD-1000

The MXD-1000 is held in place via latch hooks and clips in the Backbox. In certain circumstances, such as firmware

updates or other maintenance that requires accessing the device’s USB or Micro-USB ports, the device may need to be

removed from the Backbox.

The clips that lock down the MXD-1000’s bottom edge (Landscape) or right edge (Portrait) may be unlatched in order to

remove the device from the mounting surface.

Removing an MXD-1000 from Its Backbox

1. The MXD-1000 has three rows of ventilation holes along the molding (FIG. 23):

2. On the bottom (Landscape) or right side (Portrait) of the MXD-1000, locate the seventh and eight ventilation holes

from each edge, on the row closest to the Backbox (FIG. 24): .

3. With a stout, strong point (i.e. push pin or straightened paper clip), carefully press into the access holes in either end

of the molding until the snap is disconnected.

To facilitate the disconnection, grasp the bottom of the panel (Landscape) or right side (Portrait) and pull gently

outward until the side of the panel is free of the snap. Use your other hand to hold stable the front of the touch panel.

4. When the first side is free, repeat the process with the other.

5. With the edge of the touch panel free, carefully lift up and out (Landscape) or to the left and out (Portrait) to remove

the touch panel from the Backbox.

FIG. 23 MXD-1000 Molding (highlighted in blue)

FIG. 24 Bottom View (Landscape) or Right-Side View (Portrait) of the MXD-1000 showing access holes in molding

Molding Molding

Access holes Access holes

Panel (surface)

#7, #8 #8, #7

Always pull on the frame of the touch panel. NEVER pull on the glass edge.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 61 62

Sem comentários

AMX MAX-HT12T Manual de Instruções Página 28