AMX Network Device TX-CTB Manual do Utilizador descarregar pdf (Página 11)

3. Expand the listing for the NI WSN gateway in the

NI LabVIEW project to see the NI WSN-32xx nodes

connected to it. Expand each node to list the I/O variables.

If the gateway is not on the local subnet, complete the

following steps:

a. Right-click the project name and select New»Targets and

Devices, click Existing target or device, and click

Specify a target or device by IP address.

b. Select IP Address and enter the IP address.

c. Expand the WSN Gateway folder and select the Gateway

type and click OK.

d. To add the nodes, right click the gateway in the project and

select New»Targets and Devices. Expand the WSN Node

folder, select the node, and click OK.

1 2 ... 6 7 8 9 10 11 12 13 14

Sem comentários

AMX Network Device TX-CTB Manual do Utilizador Página 11