AMX NI-3100 Manual do Utilizador descarregar pdf (Página 16)

Chapter 2 Installation and Configuration

Entering BIOS Setup

To start the BIOS setup utility, complete the following steps:

1. Power on or reboot your NI 3100/3110.

2. When the message

Press <DEL> to enter SETUP appears, press

<Delete>. The message

Entering Setup appears briefly, and then

the BIOS setup program is entered.

3. When you first enter the BIOS program, it displays the Main menu.

Use the following keys to navigate through the BIOS setup:

• Left, right, up, and down arrows—Use these keys to move between

different setup menus. Press <Esc> to exit a submenu. Be sure number

lock is off to use the numeric keypad arrows.

• <Enter>—Use this key either to complete a submenu or display all

available settings for a highlighted configuration option.

• <Esc>—Use this key to return to a parent menu of a submenu or cancel

an outstanding selection. At the main menu, use this key to exit the

BIOS setup.

• <+> and <–>—Use these keys to cycle between all available settings.

• <Tab>—Use this key to select time and date fields. When entering

time and date information, you can also use the number keys to enter

the time and date directly.

Clearing System CMOS

The NI 3100/3110 contains a battery-backed memory for storing BIOS

configuration information.

Follow these steps to clear the CMOS contents:

1. Shut down and remove power from the NI 3100/3110.

2. Turn the NI 3100/3110 upside down (with the heatsink facing

downward).

3. Remove the bottom plate from the chassis by removing the

eight retaining screws.

4. Disconnect the 2.5 in. HDD or SSHD cable, noting the pin 1

orientation.

5. Locate the jumper for clearing the CMOS contents, as shown in

Figure 2-1. (For clarity, the heat spreader is not shown in the figure.)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 62 63

Sem comentários

AMX NI-3100 Manual do Utilizador Página 16