Amx ENV-VST-C Manual do Utilizador descarregar pdf (Página 21)

Installation and Wiring

iewStat Color Communicating Thermostat

The sensor has a 1" head that protrudes from the wall and a connected wire that plugs into a port on the

thermostat. You can use a maximum of 300 ft (91.44 m) of wire for connecting the indoor/outdoor

remote sensor to the thermostat.

FIG. 11 Indoor/Outdoor Remote Sensor

Follow these steps to install the indoor/outdoor remote sensor:

1. Drill a 1/4" hole into the surface where you want to install the sensor.

2. Fish the cable that connects to the sensor through the 1/4" hole in the wall until the edge of the

sensor, where the cord meets the sensor, is flush against the wall.

3. Apply caulk, drywall putty, insulation, or any other appropriate sealant to the hole in the wall

around the sensor to seal the hole.

4. Attach the connecting wires from the sensor to the S1 and S2 terminals on the thermostat (see

FIG. 12). It does not matter which wire you connect to either terminal.

FIG. 12 Indoor/outdoor sensor wiring to S1 and S2 terminals

Connecting wires

Sensor head

Sensor wires

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 41 42

Sem comentários

Amx ENV-VST-C Manual do Utilizador Página 21